SC-S30600 Series Revision B
ADJUSTMENT Counter Reset 229
Confidential
4.7 Counter Reset
Whenever the parts/units which have life counter are replaced, the corresponding life
counter must be reset. This is important to replace those parts/units at the correct
timing.
EXECUTION MODE
Serviceman Mode
PROCEDURE
1. Turn the printer ON in the Serviceman Mode.
Turn the power ON while pressing [Menu] + [Back] + [OK].
2. Start the Service Program and click [FLAG CHANGE & COUNTER RESET]
from the main menu.
3. Choose one of the counter reset menus to be reset.
4. Click [Run] to reset the counter.
5. Click [Finish].
6. Restart the printer.
7. With NVRAM Viewer, verify that the counter has been reset to “0”.
8. Turn the printer OFF.
Figure 4-11. [FLAG CHANGE & COUNTER RESET] Screen
Table 4-10. Clear Counter Menu List
Replaced Part/Unit Clear Menu Name
Motors
CR Motor CR Motor Counter
PF Motor PF Motor Counter
APG Motor Assy APG Motor Assy Counter
Reel Motor (standard roll) Reel Motor Counter (Standard roll)
Reel Motor (heavyweight roll) Reel Motor Counter (Heavyweight roll)
ATC Motor (standard roll) ATC Motor Counter (Standard roll)
ATC Motor (heavyweight roll) ATC Motor Counter (Heavyweight roll)
Ink
System
Printhead Print Head Counter
Dumper Kit Selfsealing Valve Counter
Pump Cap Unit Pump Cap Unit Counter
Ink Holder Ink Holder Counter
Ink tubes Ink tube Counter
To Next Page
Loading...
Need help?
General