Epson SC-S30600 Series User Manual

SC-S30600 Series Revision B
MAINTENANCE Setting Up/Storing the Printer 278
Confidential
5.2 Setting Up/Storing the Printer
5.2.1 Setting Up
Make sure to open up the following installation room for the printer so as to maintain
appropriate operation and usability.
Figure 5-1. Installation Room Requirement
5.2.2 Storing the Printer
When storing the printer, make sure to leave the ink cartridges installed and place it on
a horizontal surface, and also inform the user on the following cautions.
 When not using the printer for a long time
 Turn on the printer at least once a week to let it clean the nozzles and prevent
clogging of the nozzles.
 Remove the media. If the media is left set for a long time, nip impression of
the Press Roller may remain on the media, or the media may ripple.
 Check that the Printhead is capped properly.
 Close all the covers.
 When storing the printer for a long time, evacuate the ink and flush the ink
passage. (See “4.12.2 Tube Inner Cleaning” (p258).)
 Before using the printer again
Make sure to print a nozzle check pattern and check for clogging of the printhead.
If any clogging can be seen, carry out a head cleaning.
C H E C K
P O I N T
After performing the head cleaning a few times, try turning off the
printer and leaving it overnight or longer, so that the ink may
dissolve and the clogging might be improved.

Epson SC-S30600 Series Specifications

General

Brand	Epson
Model	SC-S30600 Series
Category	Printer
Language	English