How to Activate the Continuous Timecode Regeneration
To activate the continuous timecode regeneration, proceed as follows:
1. In the Playlist page (F10), press TAB several times until the ON/OFF field after
‘Regeneration of TC’ is green highlighted.
2. Press the right arrow key to toggle the function to ON.
3. Press TAB again to highlight the 'continuous in PLST' text segment, and, with the
right arrow, select whether the regeneration will be applied on the playlist (PLST) or on
the playlist clips (CLIPS).
4. Press TAB to highlight the 'from 00:00:00:00' segment, and type the start TC to be
used for the regeneration.
5. Press TAB again to highlight on the timecode type, and toggle to the requested
timecode type with the right arrow.
The continuous timecode regeneration function is now active. However, the timecode will
effectively be regenerated when you replay the playlist after activating a loop.
To deactivate the function, press the left arrow on the field to toggle the function to ‘OFF’.
How to Regenerate the Timecode in a Playlist
To regenerate the timecode in a given playlist, proceed as follows:
1. Activate the TC Regeneration and define the related settings on the Playlist page
(F10), in the blue-highlighted area at the bottom of the page. This feature is defined for
each playlist individually:
2. Activate the internal loop using the SHIFT+Loop keys
3. Roll the playlist.
This will record the playlist back into the recorder channel 1 (CAM A) with the regenerated
timecode.
5.7. Operations on Clips in Playlists
5.7.1. Adding Clips in a Playlist
Introduction
You can add clips to a playlist in different ways, but always from the Remote Panel:
• Adding clips at the end of the current playlist without entering the Playlist Edit mode.
• Inserting clips before or after the clip selected in the loaded playlist.
• Adding one or more clips returned by a search at the end of the current playlist.
OPERATION MANUAL Multicam LSM 12.05
5. Playlist Management 95
To Next Page
Loading...
Need help?
General
