4.4.4. Deleting Clips
Introduction
You can delete any clip available on disks as well as growing clips, but:
• Loaded clips cannot be deleted.
• Clips that are on air cannot be deleted.
• In network mode, clips included in a playlist or currently used by another operator
cannot be deleted.
In these cases, a warning message is displayed.
Additionally, the deletion must be confirmed in the warning message box that appears:
• When the clip is protected.
• When the Confirm del clp/plst parameter is set in the Operational Setup menu (p.5.1
F3).
Note
When a clip is deleted, all playlists are scanned and that clip is removed from all
of them.
In the Remote Panel Interface
Deleting a Single Clip
Note
The F_key corresponding to the clip location on the Remote Panel must be
green to be able to delete it.
To delete a clip, proceed as follows:
1. Select the page and bank where the clip that you want to delete is stored.
2. Press CLEAR, then press the F_ key corresponding to the clip.
Warning
In most cases, no confirmation is required and the clip will be instantly deleted.
3. If a confirmation message appears, press ENTER to confirm the selected clip
deletion.
OPERATION MANUAL Multicam LSM 12.05
4. Clip Management 61
To Next Page
Loading...
Need help?
General
