To Next Page

To Previous Page

• Press the SHIFT+D to enter this mode. The menu will change, as shown above.

• Press the <–Lf–> key, and move the command knob to centre the left side picture.

• Press the <–Rg–> key and do the same operation for the right side picture.

• To restore the default positions, press CLEAR+<–Lf–> and CLEAR+<–Rg–> .

• Press the <–WP–> key to move the border. To restore the default position of the

border press CLEAR+<–WP–> .

• To exit the SHIFT mode, press the SHIFT+D again.

Note

If working in network mode, split screen can be performed on remote clips as

well as on local clips.

Auto-tracking mode

The Auto-tracking mode applies only to the Vertical Split mode, and allows to adjust the

horizontal position of a sequence to make sure it is as close as possible to the centre of

the left/right part of the screen.

To use the Auto-tracking, the first step is to track the object that must be kept in the centre

of the frame. Using the Target Track mode the keyframes are marked to determine the

path of the object.

When the tracking is completed in the desired clips, enter the Split Screen mode and

recall these clips on the left and right side of the screen. If keyframes have been marked

inside selected clips, the word “TRACKED” will appear on the corresponding side of the

output monitor. At playback, the picture will be shifted horizontally to keep the tracked

object in the centre of its frame.

To disable temporarily the auto-tracking without leaving the Split Screen mode, press

CLEAR+LEFT (disables Auto-tracking on left side) or CLEAR+RIGHT (disables Auto-

tracking on right side).

9.4.3. Using Horizontal Split

The Horizontal Split function is controlled from the Remote Panel:

PGM1 CAM A *PGM2* CAM B

Aud.Met. PgmSpd Sort->TC PostRoll

Sw to IN Search Pref

P.1 B.1 Clips: LOCAL Records: LOCAL

PL 11: <

Msg:

H Split Swap Sync

Top Bottom T & B SHIFT

Press the SHIFT+D to switch between normal and special commands:

H Split Swap Sync

<-Tp-> <-Bt-> <-WP-> SHIFT

OPERATION MANUAL Multicam LSM 12.05

9. Advanced Control Modes 199

EVS Multicam LSM User Manual

Other manuals for EVS Multicam LSM