The following effect types are available:
Command Description
C Cut
M Mix
W Wipe
> Fade to color
< Fade from color
V Fade to/from color
4. To modify the default duration for the transition effect, press FX Dur (C) and move the
lever until the requested duration is displayed in the last field of the corresponding
element:
111A/04 Clipname012 00:00:29 Unk W00:20
5. Press ENTER to validate the modifications in effect type and/or duration.
5.8.3. Swapping Audio Tracks
Introduction
The swap audio tracks mode allows swapping audio tracks between two points in a
playlist. This function can only be executed on the Remote Panel.
• The Auto mode replaces:
◦ audio tracks 1&2 by audio tracks 3&4 in four audio mode
◦ audio track 1 by audio track 2 in stereo mode.
• The Manual mode lets you choose which tracks to replace.
In 8- and 16-track modes, you only have access to the manual mode.
Note
You need to enable the Advanced audio editing parameter in the Operational
Setup menu (p.3.2 F2) to be able to use the Swap audio tracks feature. The
access to this parameter, and to the Swap audio tracks feature, requires the
license code 112 being installed, and is only available on an XT3 or XT2+
chassis.
OPERATION MANUAL Multicam LSM 12.05
5. Playlist Management 109
To Next Page
Loading...
Need help?
General
