5.8.9. Adding an Auxiliary Audio Clip
Introduction
This option allows adding a new stereo audio track (e.g. sport comments, music, jingles,
ambient sound) to the original video clips. This is only available from the Remote Panel.
This stereo audio track is available on the PVW output and on analogue outputs 7/8 or on
digital outputs 15/16. The selection of the track output is done with the Audio slow motion
parameter in the Operational Setup menu (p.8.1 F1).
The original audio tracks are still available on outputs 1/2 (3/4). The auxiliary audio clip
selected is always played back with normal speed (100%), whatever the selected
playback speed for the video.
When the playback of the playlist is not started from the beginning, the system calculates
the offset between the current position and the beginning of the playlist, and applies the
same offset to the Aux. Clip, so that it can remain synchronized with the playlist.
If the duration of the Aux Clip is longer than the playlist duration, the auxiliary audio clip
keeps playing even after the video has stopped. Otherwise, the audio clip ends itself
before the end of the playlist, when the audio clip reaches its OUT point.
How to Add and Remove an Auxiliary Audio Clip
To add/remove an auxiliary audio clip to a playlist on the Remote Panel, proceed as
follows:
1. Activate the Aux.Clip button by selecting a clip from the clip bank.
◦ This can be done outside of the PLST EDIT mode, or in PLST EDIT mode with
PRV CTRL ON.
◦ The Aux Clip option appears in the secondary menu on the Remote Panel.
2. Press MENU to call the secondary menu.
3. Press Aux.Clip button (SHIFT+B).
◦ The ID of the Aux Clip appears in the title bar of the Playlist screen (F10)
4. To remove the current aux. clip:
◦ Load the aux clip.
◦ Pressing MENU to open the secondary menu.
◦ Press CLEAR+SHIFT+B (Aux. Clip) on the Remote Panel.
128 5. Playlist Management
EVS Broadcast Equipment SA Issue 12.05.A- May 2014
To Next Page
Loading...
Need help?
General
