OUT Key Colors in Playlist Mode
• When the Playlist is sitting on the Video and Audio OUT point of a Clip, the OUT key
will light red.
• When the Playlist is sitting on the Video OUT point of a Clip, the OUT key will light
green.
• When the Playlist is sitting on the Audio OUT point of a Clip, the OUT key will flash
red.
• If the Playlist is in a position where the Audio and Video are synchronous, the IN/OUT
keys will be green.
• If the Playlist is in a position where the Audio and Video OUT points have been split,
the OUT key will flash green.
Example on Audio Delay Edit
Note
Transitions are reset to zero on INSERT and DELETE functions.
5.8.8. Using the Replace Function
Introduction
The purpose of the Replace function is to consolidate the effects defined on a playlist as
follows:
The operator loops a section or an entire playlist back to themselves and, during the
playback, add some effects externally (graphic insertion for instance) or internally
(changing the speed).
While the operator plays the playlist back, and inserts the requested effects, the playback
result is re-injected into the playlist from a predefined IN frame. The OUT point of the
replaced section is predefined or manually defined in the record process.
The Replace function is only available on the Remote Panel.
Note
The Replace function is not allowed on playlists containing growing clips.
The Replace function is not supported on 4K configurations.
124 5. Playlist Management
EVS Broadcast Equipment SA Issue 12.05.A- May 2014
To Next Page
Loading...
Need help?
General
