Accessing the Replace Function
Press MENU in Playlist Edit mode to open the secondary menu with the Replace
function. Select Replace in this menu to access the Replace function :
Clr Unav OtherAng
Replace MakeLoc Redo Undo
Replace Edit Mode
This mode allows to specify the following information for the Replace:
• IN point and OUT point, for the section to replace in the playlist. The OUT point can
also be defined during the Replace itself.
• Loop mode parameters.
In the Replace Edit mode, the playlist is considered as one entity on which you can mark
one IN point and one OUT point (pressing the IN and OUT points does not retrim the
current playlist clip).
Those IN and OUT points will be used to determine what portion of the playlist will be
replaced.
Replace Playback Mode
In this mode, you play the playlist back and insert the new section between the defined IN
and OUT points.
After you have selected the required settings for the Replace function, the Replace
Playback mode is automatically activated: the playlist is cued before the IN point (to
create guardbands), ready to be initiated.
The playlist is played at the speed defined in the playlist but the lever can also be used to
vary the playback speed.
When the Protect OUT point of the clip is reached, a clip containing the IN and OUT
points with the guardbands is created on the Receive page defined in the Setup menu.
The loop is stopped and the user switches back to match Frame Edit mode.
Methods
You can perform a Replace action in two ways:
• By defining an IN and OUT points in the Replace Edit mode.
• By defining only an IN point in the Replace Edit mode, and defining the OUT point
while you perform the Replace in the Replace Playback mode.
Warning
The IN and OUT points cannot be marked on a transition (including split audio
transitions and swap zones) or on a split zone (the key will flash red when it is
the case).
OPERATION MANUAL Multicam LSM 12.05
5. Playlist Management 125
To Next Page
Loading...
Need help?
General
