Multicam Behavior
When adding a cut to a clip, Multicam will behave as follows:
• The transition applied at the cut point is a cut (for both audio and video).
• The speed of the cut elements is the same as the original element, even if it is
“Unknown”.
• The stop and start modes of the cut elements are auto.
• Any loop defined on the playlist that includes the original element conserves and
includes the cut elements.
• Any tag defined and active on the original element at the cut point is recreated at the
short-in of the second cut element.
How to Add Cut to a Timeline Element
To add a cut to a timeline element in a timeline opened in Edit mode, proceed as follows:
1. Jog to the position where you want to add a cut.
2. Press MENU to access the Edit mode secondary menu.
3. Select the Add Cut option (B key) in the secondary menu.
The timeline element is cut in two parts that keep the same LSMID.
6.4.4. Inserting Material into a Timeline
Overview
Description
The Insert feature in Multicam consists of inserting new material into the timeline. The
timeline is loaded on the recorder and the material to insert is loaded on the player.
The Insert action can be done as a three-point edit or four-point edit.
The Insert action can be done in Insert or Overwrite mode.
This action is only possible on the Remote Panel.
Insert or Overwrite Mode
If the Insert action is performed in Insert mode, the material 'covered' is moved to the right
of the timeline. The timeline duration is increased by the duration of the inserted material.
If the Insert action is performed in Overwrite mode, the material 'covered' is overwritten
by the inserted material. The timeline duration is not modified.
OPERATION MANUAL Multicam LSM 12.05
6. Timeline Management 141
To Next Page
Loading...
Need help?
General
