5.6. Operations on Playlists
5.6.1. Setting and Loading Playlists
Introduction
A distinction is made between setting and loading a playlist:
• When you load a playlist, you actually load it on a given player channel either to edit it
or to play it out.
• When you set the current playlist, you access the playlist location on the server but
you do not load it on a player channel. Thus you can insert clips directly in the current
playlist without having to load it onto a channel.
Note
At Multicam startup, the current playlist is automatically playlist 11,that is the
playlist 1 on bank 10 of page 1.
How to Set the Current Playlist
In the Remote Panel Interface
To set the current playlist, proceed as follows:
1. Only if you want to select a distant playlist, first press SHIFT+Network then press the
F_ key corresponding to the server on which the playlist is located.
2. Press SHIFT+Page+F_ key to select the page in which the desired playlist is located.
3. Press SHIFT+F10 to select the playlist bank.
4. Press F_ key to select the desired playlist.
5. Press ENTER to confirm.
To load the current playlist, continue as follows:
6. Press PLST to load the current playlist on a player channel (it cannot be empty).
To exit the playlist mode:
7. Press the RECORD key to return to E2E mode.
◦ If the new playlist is not empty, it is automatically loaded on the selected player
channel (in 3 PGM mode) or on the PGM (in PGM/PRV mode) and it becomes the
current playlist.
◦ If the new playlist is empty, the system will ask you whether you want to copy the
current playlist at this new location.
Note
Page 1 contains playlists 10 to 19, Page 2 contains playlists 20 to 29, and so on.
OPERATION MANUAL Multicam LSM 12.05
5. Playlist Management 85
To Next Page
Loading...
Need help?
General
