OtherAng
The OtherAng (Other Angle) function (SHIFT+C key) allows the operator to replace the
current playlist element by another playlist element showing a different angle of the
recorded material.
When the OtherAng option is selected, Multicam loads the local and network trains that
include the TC IN of the playlist element to replace. The trains are loaded on the PRV
channel, at the current TC of the loaded element. The jog is used to shift from one record
train to the other.
Once the requested record train is displayed on the PRV channel, pressing ENTER
replaces the current playlist element by the one created from the selected angle.
Add cut
The Add cut function (SHIFT+D key) allows the operator to split an existing clip into two
independent clips at a selected point. Both resulting clips are duplicates of the original one
with additional short-in and short-out points added at the split point.
5.3.3. Functions in Playlist Playout Mode
Once the playlist is cued and ready to roll, the menu below is displayed on the Remote
LCD. This menu gives the operator the ability to manipulate the playlist while it is playing.
The duration displayed in the top right corner of the LCD screen in Playlist Playout mode
is the remaining duration until the end of the playlist.
PL11 LSM 04 Albert LOC LEFT=00:00:02:22
111A Clipname01200:00:29UnkW00:10
112B/03Clipname45600:53:29 UnkM00:10
112B Clipname89100:53:29 UnkM00:10
2nd CTRL
Film FX Next Skip Edit
Film FX
Selecting this function will create a film style effect during the playout of the playlist by
repeating one field every two fields. Please note that the audio is not affected by this
effect. This mode is deactivated when exiting a playlist.
Next
While the playlist is rolling on air, selecting the Next function will start the transition of the
next clip with the transition effect listed on the playlist. This can be used if a clip is running
too long and it is necessary to shorten up the playing time.
80 5. Playlist Management
EVS Broadcast Equipment SA Issue 12.05.A- May 2014