EVS Multicam LSM User Manual

Enabling the Audio Swap Mode
To enable the Audio Swap mode, proceed as follows:
1. Enter the Setup menu.
2. Select the Swap audio tracks parameter value in the Operational Setup menu (p.3.2
F4).
3. Choose the Auto or Manual value.
Swapping Audio Track in Auto Mode
To perform a swap audio track in Auto mode, proceed as follows:
1. In Playlist Edit mode, select the Video Base mode (V Base) by pressing SHIFT+. The
LCD screen will now display additional function:
PL11 LSM01 Paola LOC TDUR=00:00:02:22
111A/04 Clipname012 00:00:29 Unk W00:10
112B Clipname456 00:53:29 Unk W00:10
112B/02 Clipname891 00:53:29 Unk W00:10
V Base A Base Swap
A Advanc A Delay A FX DUR A Split
2. Press the Swap function (SHIFT+D).
3. Jog your playlist until you reach the point where you want to change the audio tracks.
4. Mark an IN point.
The OSD screen indicates the following information:
In dual stereo mode:
*PL11/03* LEFT 06:42:22
V Mix 02:25 Spd.Unk
A Mix 02:25 A.Del. 00:00
IN-00:00:00 OUT+00:00:27
00:10
1→3 3→3
2→4 4→4
12:23:45:13 00:07:13 100
112B/04 ClipName 999/999
In stereo mode:
*PL11/03* LEFT 06:42:22
V Mix 02:25 Spd.Unk
A Mix 02:25 A.Del. 00:00
IN-00:00:00 OUT+00:00:27
00:10
1→2
2→2
12:23:45:13 00:07:13 100
112B/04 ClipName 999/999
5. Press the Swap function again (SHIFT+D).
6. Jog your playlist until you reach the point where you want to reset the original audio
tracks.
7. Mark an OUT point.
110 5. Playlist Management
EVS Broadcast Equipment SA Issue 12.05.A- May 2014

EVS Multicam LSM Specifications

General

Brand	EVS
Model	Multicam LSM
Category	Remote Control
Language	English