CAM Keys
When you press a CAM key corresponding to a recorded block, this loads the last
recorded frame of the selected block in play mode.
When you press a CAM key corresponding to a block in REC, this loads the last recorded
frame of the selected block in play mode, and the recording starts on the next empty
block, if available.
When you press a CAM key corresponding to an empty block, the remote beeps.
CLEAR
Press the CLEAR key to clear the recorded material on a block. It can be used in the
following ways:
• To clear the record on a given block that is not in PLAY mode, press CLEAR and the
CAM key corresponding to the requested block.
• To clear the record on a block when the block is in PLAY mode, press CLEAR. The
PLAY is stopped, the recorded material is deleted from the block, and the camera
automatically starts recording again in this block if it is not recording on any other
block yet.
Note
The CLEAR button is only active on some cameras.
LCD Menu on the Remote Panel
Hypermotion Main Menu
The hypermotion main menu displays the memory blocks that have been selected in the
#Blocks parameter of the hypermotion secondary menu. The memory blocks use is
described later in this chapter.
Only the activated blocks will be displayed and the highlighted block is the one the
operator is currently working on.
Off Ramp UP SpeedBrk LSM Mode
Block 1 Block 2
Cues Parameter
This parameter allows you to activate the cue management in hypermotion mode.
The default value of the Cues parameter is On.
Off Ramp UP SpeedBrk LSM Mode
Block 1 Block 2
OPERATION MANUAL Multicam LSM 12.05
9. Advanced Control Modes 205
To Next Page
Loading...
Need help?
General
