• If no default target is defined, the list of machines available on the network will appear.
As soon as the operator selects one of them, the clip is pushed.
Depending on the push settings defined, the default targets or the list of possible targets
submitted to you will contain EVS servers on the SDTI network and/or EVS servers on
the GbE network.
For more information about the Push settings, refer to the Operational Setup menu on the
Remote Panel, page 7.1.
In both cases, a message appears for a few seconds on the LCD to confirm that the clip is
being pushed and indicate the clip location where it will be stored on the receiving
machine.
If the Receive Page(s) defined on the destination machine is (are) full, the operator who
tries pushing the clip is notified. While this message is being displayed, the operator can
press the MENU key at any time to return to the normal menu. Depending on the
CAM/CLIP mode selected by the D key, only the camera angles loaded on the controlled
channels are pushed (CAM mode), or all camera angles of the clip are pushed at once
(CLIP mode).
>Archive
Push Aux Clip Sort->TC PostRoll
>Archive *** Name Cam
The Archive function allows the operator to flag a clip to place it in the archive queue of the
XFile defined in the Operational Setup menu (p.7.1 F3). The EVS Xfile is a 2U device with
2 removable hard drives, that can be connected to the XNet SDTI network. Clips can be
archived to/restored from the removable media.
This function is blinking when the clip is flagged for archiving, but has not yet been
archived. It is permanently highlighted when the archiving of the clip is completed.
Depending on the mode selected with the D key (CLIP/CAM), the >ARCHIVE flag is
assigned only to the camera angles of the clip loaded on the controlled channels (CAM
mode), or to all camera angles of the clip (CLIP mode).
Aux Clip
Push Aux Clip Sort->TC PostRoll
>Archive *** Name Cam
This function allows assigning a clip as auxiliary audio clip to the current playlist. Press
CLEAR+Aux Clip (CLEAR+SHIFT+B) to remove the current auxiliary clip. "Playlist
Management" on page 75 for more details.
40 4. Clip Management
EVS Broadcast Equipment SA Issue 12.05.A- May 2014
To Next Page
Loading...
Need help?
General
