194
EF2
EF2: Foam warning
EF2
Incorrect or excessive detergent, Drain pipe blocked or clogged.
Checks to perform :
1. This is an excessive detergent dosing warning. The system detected dense foam during the drain phases. Therefore, use
the correct quantity of detergent and make sure the filter and drain circuit are clean.
2. Excess of suds is generated that causes the overheating of motor because of the improper quantity or quality of
detergent. In the future, reduce detergent dose or use high efficient (HE) detergent.
3. Alarm is silent and the cycle is extended.
EF6
EF6: Safety reset
EF6
Main Control Board defective.
Checks to perform :
Replace the Main Control Board and repeat the Diagnostic Cycle to check for any further alarms.
WARNING
Check that all the connectors are correctly inserted.
WARNING
Check that all the connectors are correctly inserted.
To Previous Page
Loading...
Need help?
General
