7
Warnings
• Any work on electrical appliances must be carried out by qualified professionals.
• Confirm that the power system is operational before working on the appliance.
• Check that the appliance is restored to its original safety condition after the operation is complete.
• Take the plug out of the socket to disconnect the power supply before you access internal componenets. This platform is
not fitted with an ON / OFF switch.
• Warning sensors located on the display board could be at a potential of 220 Volts (If applicable).
• Do not place any container under the appliance to avoid collecting drips of water.
• Always empty the appliance before laying it on its side for any servicing.
• The resistance values of the components shown in this Service Manual (SM) are purely indicative and approximate.
• Replace the heating element with one that has the same characteristics to maintain safety
measures for the appliance.
• Ensure gas pipelines are connected properly as mentioned in the installation section for gas
dryer models.
• Lay down the machine on either side while servicing the unit. In such cases, some water in the detergent dispenser could
sip into the electrical / electronic components and cause these to burn.
• Always place the cotton cloth below the machine to absorb water. There is a possibility of water leakage while servicing
the Drain Pump and Dispenser.
2. Warnings
To Next Page
Loading...
Need help?
General
