8 Tools
148
Tools
8
IPv6 Address Solution
Sets IPv6.
Set IPv6
Sets whether to use IPv6.
You can select [Disable] or [Enable].
[Disable] is set at the time of factory shipment.
IP Address
Use the numeric keypad to enter the IP address.
Prefix
Use the numeric keypad to set the prefix length of the IP address (between 1 to 128).
Gateway Address
Use the numeric keypad to enter the gateway address.
IP Mode Settings
Sets the TCP/IP operation mode.
[IPv4] is set at the time of factory shipment.
Dual Stack
Select this setting when using the machine in an environment using both IPv4 and IPv6.
IPv4
Select this setting when using the machine in an IPv4 environment.
IPv6
Select this setting when using the machine in an IPv6 environment.
Ethernet Rate Speed
You can select [Auto], [10BASE-T Half], [10BASE-T Full], [100BASE-TX Half], or [100BASE-TX
Full].
[Auto] is set at the time of factory shipment.
IP Filter Settings
Sets whether to restrict the IP addresses that can access the machine.
Note • The IP filter is a function used to suppress printing using TCP/IP.
• This setting is activated after restarting the machine.
IPv4
Sets whether to restrict the IPv4 addresses that can access the machine. When this setting
is enabled, you can register up to 10 IP addresses/subnet masks to support.
To Next Page
Loading...
Need help?
General
