Fuji Xerox DocuCentreS2520 User Manual

4 Loading Paper
90
Loading Paper
4
Changing Paper Size
This section describes how to change paper size in Trays 1 to 4.
Important • Do not load mixed paper sizes into a tray.
Note • A paper type is preset for Trays 1 to 4. Normally, [Plain 1] is set for the trays. When changing it to a
different paper type, change the paper quality settings to match the type of paper to be loaded so
that you can maintain high quality printing. For more information on how to set the paper quality,
refer to "Changing the Paper Settings" (P.92).
Changing the Paper Size for Trays 1 to 4
The following describes the procedure for changing paper size in Trays 1 to 4.
1 Pull out the tray until it stops.
Important • While the machine is copying or printing, do not
pull out the tray that the job uses.
• To prevent paper jams or loading errors, do not
load different sizes or types of paper on top of
any remaining paper in a tray.
2 Remove any paper loaded in the tray.
3 For Tray 1, push down the metal plate.
4 While pinching the levers of the two paper
guides, move them to the edges of paper.

Fuji Xerox DocuCentreS2520 Specifications

General

Brand	Fuji Xerox
Model	DocuCentreS2520
Category	Printer
Language	English