8 Tools
150
Tools
8
Copy Settings
Used to set the functions for the Copy feature.
For information on how to display the [Copy Settings] screen, refer to "System Settings Procedure" (P.136).
Lighten/Darken
Sets the default copy density value displayed in [Lighten/Darken].
You can select [Darken +2], [Darken +1], [Normal], [Lighten +1], [Lighten +2], or [Toner
Saver].
[Normal] sets the copy density at about the same as the document; [Darken +2] sets a
higher density than the document; [Lighten +2] sets a lower density.
[Toner Saver] sets the following values for each feature to conserve the toner usage.
[Lighten/Darken]: Lighten +2, [Sharpness]: Sharpen +2, and [Original Type]: Photo& Text.
[Normal] is set at the time of factory shipment.
Original Type
Sets the default value displayed for [Original Type]. This setting optimizes the copy
characteristics for the specified document type.
[Text] is set at the time of factory shipment.
Text
Set when copying documents with sharp black and white contrast, such as text documents.
Photo & Text
Set when copying documents containing both text and photos.
Photo
Set when copying photos.
2 Sided
Set the default value displayed for [2 Sided].
[11 Sided] is set at the time of factory shipment.
1 1 Sided
Set when copying one-sided document on one side of each output page.
2 1 Sided
Set when copying two-sided document on one side of each output page.
1 2 Sided
Set when copying one-sided document on both sides of each output page.
2 2 Sided
Set when copying two-sided document on both sides of each output page.
To Next Page
Loading...
Need help?
General
