Fuji Xerox DocuCentreS2520 User Manual

2 Environment Settings
50
Environment Settings
2
[Ethernet] is displayed.
 Port Information

TCP Port Number
You can set the Port9100 port No. (a value between 1 and 65535).
You must set a unique number for each port. (Default: 9100)

Maximum Connections per Port
The maximum number of connections is displayed.

End of Job Timeout
You can set the amount of time the machine waits before terminating the connection
when incoming data stops (between 2 and 3600 seconds). (Default: 60)

PDL Switching
[Enabled] is displayed.
 [Apply] button
You can apply changes by pressing this button.
Note • Reboot machine to enable new settings.
SMTP Server (Connectivity > Protocols)
You can set the SMTP server.
 Required Information

SMTP Server IP Address/Host Name
You can enter the SMTP server's address as an IPv4 or IPv6 address or in FQDN format
(up to 256 characters).

Port Number for Sending E-mail
You can set the port number used by the SMTP server to send an e-mail (a value between
1 and 65535). (Default: 25)

Login Credentials for the Machine to access the SMTP Server to send automated e-mails
You can set the authentication method when sending an e-mail by SMTP. You can select
[None] or [SMTP AUTH]. (Default: None)

Login Name
For SMTP servers requiring authentication, enter the e-mail address of the authenticated
SMTP user (between 1 to 64 ASCII code characters). This can be left blank if SMTP
authentication is skipped.

Password
You can enter the password for authentication (between 1 and 64 ASCII code
characters). This can be left blank if SMTP authentication is skipped.

Retype Password
You can verify the authentication password you entered by re-entering it here.
 [Apply] button
You can apply changes by pressing this button.
HTTP (Connectivity > Protocols)
You can set the HTTP protocol.

Fuji Xerox DocuCentreS2520 Specifications

General

Brand	Fuji Xerox
Model	DocuCentreS2520
Category	Printer
Language	English