Scan Options
119
Normal
Uses the default values for the edge or center area to be erased. The default values
are set in [Variable Erase]. If you do not want to erase any edge and/or center area,
select [Variable Erase] and then select 0.0 using the scroll buttons.
Variable Erase
Allows you to adjust the edge or center area to be erased. Enter the amount you want
to erase from the top, bottom, right, left, and center margins. Up to 50 mm can be
entered.
Original Orientation
• Head to Top – Select to position documents with the head of the document away
from the operator.
• Head to Left – Select to position documents with the head of the document to the
operator’s left. For this orientation, documents are scanned so that the head of
scanned result is away from the operator.
Reduce/Enlarge
This feature allows you to select the enlargement/reduction ratio of the document for
scanning.
1. Select [Reduce/Enlarge] on the
[Scan Options] screen.
2. Perform the necessary
operations.
3. Select [Save].
Preset %
• 100% – Sets the enlargement/reduction ratio to 100% (original size).
• Presets – Allows you to select the preset enlarge/reduce settings. Select one of
these to specify the enlargement/reduction ratio. The presets are set up by the
System Administrator.
Variable %
Allows you to specify an enlargement/reduction ratio within the range of 25 to 400%.
Auto %
Automatically selects the enlargement/reduction ratio, depending on the size of
documents and the Output Size set. When you select this option, [Output Size] is
displayed at the right side of the screen.
To Next Page
Loading...
Need help?
General
