3 Copy
56
Variable Erase
Allows you to adjust the amount of deletion from the edge or center of the documents.
Enter the amount you want to erase from the top, bottom, right, left, and center margins.
Up to 50 mm can be entered.
Margin Shift
This feature allows you to change the position of the image on an output page.
NOTE: To use this feature, the document orientation must be specified to indicate top
of the document for [Original Orientation] on the [Scan Options] screen.
NOTE: The amount of the image shift depends on the size of paper loaded in the
machine.
NOTE: Even if you load the documents of detectable size in the document feeder, a
message may appear on the touch screen asking you to input the document size
manually, depending on features set, status of the paper in the tray, size detected by
the machine, etc.
Follow the message on the screen to enter the document size.
When you scan mixed size documents, it is recommended to load them SEF.
NOTE: When [Mixed Size Originals] is selected, the amount shifted is determined by
the image position of the first sheet and is applied to all subsequent sheets of the
documents.
1. Select [Margin Shift] on the
[Scan Options] screen.
2. Select the required option.
3. Select [Save].
No Shift
Disables the feature.
Auto Center
Automatically moves images to the center of the paper.
Margin Shift/Variable Shift
Automatically moves images by specified amounts on the paper. You can enter up to
50 mm for both dimensions.
If your machine is configured to perform double-sided copies, you can select the
options below for the front and back page copies, separately.
• Side 1 – Displays the [Margin Shift - Side 1] screen.
• Side 2 – Displays the [Margin Shift - Side 2] screen.
To Next Page
Loading...
Need help?
General
