12 Setups
186
Relay Broadcast Report
Specify whether to automatically print a Relay Broadcast Report for fax jobs. A Relay
Broadcast Report shows the result of fax transmissions for relay broadcasting.
Off
Disables the feature.
Send to Relay Station
Causes the machine to automatically send a Relay Broadcast Report to relay stations.
Print at Local Station
Causes the machine to automatically print out a Relay Broadcast Report.
Send to Relay, Print at Local
Causes the machine to automatically print out a Relay Broadcast Report and send it to
the relay stations.
2 Sided Report
Specify whether or not a report is to be automatically output to both sides of paper if
the report will not fit on one side.
Recipient on Activity Report
Specify the number of characters of the destination’s information to be printed on an
Activity Report. Select [First 40 characters] or [Last 40 characters].
Maintenance/Diagnostics
Use this feature to initialize the hard disk on the machine or delete all document data
stored in the machine.
1. Select [Maintenance/
Diagnostics] on the [Common
Settings] screen.
2. Perform the necessary
operations.
3. Select [Close].
Initialize Hard Disk
Use this feature to initialize the hard disk on the machine. After selecting [Initialize Hard
Disk], select a partition, and then select [Start]. Then select [Yes] to execute
initialization. After the initialization finishes, select [Confirm].
NOTE: This process may take a while depending on the machine configuration.
Delete All Data
Use this feature to delete all document data on the machine. Select [Delete All Data],
and then select [Start]. Then select [Yes] to execute deletion. After the deletion finishes,
you need to switch the machine off and then on.
NOTE: This process may take a few hours depending on the machine configuration.
To Next Page
Loading...
Need help?
General
