10 CentreWare Internet Services
142
Job Templates
This page allows you to view the list of job templates registered in the machine, create
new templates, or modify the existing ones. Job templates can be created in different
settings by selecting features such as resolution and file format. Up to 250 templates
can be stored in the optional hard disk of the machine.
Up to 20 templates are listed alphabetically on the [Device Templates] screen. Click
[Next] or [Previous] to view the next or previous page. [First] and [Last] buttons are also
available to skip to the beginning and the last pages of the list, respectively.
If you apply any template to a scan job, retrieve the job template first on the machine.
To create or change job templates, follow the steps below.
1. Click the [Services] tab on the Header Panel of the CentreWare Internet Services
home page.
2. Select [Job Templates].
3. Click [Display Job Template Screen].
4. The Job Template page with the list of device templates is displayed.
5. Select [Templates], [File Repository Setup], [Pool Setup], or [General Settings] on
the righthand corner of the Job Template page as required.
6. Perform the necessary operations.
Template
This page allows you to view the saved job template, create a new template, and edit,
copy, or delete an existing template.
Create New
To create a new template, click [Create New] at the top right corner of the Template
page. Click [Next] or [Back] to proceed to the next page or return to the previous one,
respectively. Click [Cancel] to stop the operation. After editing, click [OK]. The template
is then saved. You can view the saved templates by clicking [List].
NOTE: When creating a new template, using the same job template name on different
templates is not allowed. An error message will be displayed if the same template
name is used.
The following table shows the setting items available on the [Create New] page, the
[Basic Scanning], [Added Features], [Image Quality], and [DMF] tabs. When [Create
New] is selected on the [Device Templates] screen, the [Create New] page is
displayed. To select the required tab, click [Next] to go to next page.
Setting Item Description
Template Name Enter the name of the template.
Description Enter the description for the template.
Repository Type Select the method of specifying how scanned data is
stored. When [Public] is selected, you can select the
existing repository setup from the drop down menu
displayed. When [Private] is selected, you can configure
the repository manually.
To Next Page
Loading...
Need help?
General
