3. Complete one of the following steps depending on the message(s) you want to record.
• To record a message, scroll to the relevant menu option and press OK. For example,
to record the leader message, scroll to Leader Message and press OK.
• To record a single event message, scroll to Single Event Message and press OK.
Select the number of the message (1-15) and press OK.
4. Press the recording/playback button on the NX-535 voice module and record the
message.
5. After you record a message, press the recording/playback button to stop recording. The
message is played back.
6. If you are satisfied with the message, press the recording/playback button to record the
next message. Do not start recording the next message while the recording/playback LED
is lit.
7. To re-record a message, press the recording/playback button twice in quick succession
and re-record the message.
8. Record all messages finishing with the address message.
Playing back messages
Pre-recorded voice messages can be played back altogether or one at a time. The following steps
explain how to playback different messages.
1. Connect a telephone handset to the phone jack on the NX-535 voice module.
2. Navigate with the ½¾ keys to NX-535 Voice Module>Playback and press OK.
• To playback one message at a time, scroll to the relevant menu option and press OK.
• To playback a single event message, scroll to Single Event Message and press OK.
Select the number of the message (1-15) and press OK.
3. Press the recording/playback button on the NX-535 voice module to playback the message.
4. Press the recording/playback button to playback the next message.
Configuring handshake and kiss off
Handshake and kiss off can be programmed as any key press or as a specific telephone key. The
following steps explain how to configure these digits.
Note: The voice protocol cannot generate a ‘fail to communicate’ signal.
1. Navigate with the ½¾ keys to NX-535 Voice Module>Handshake Digit and press OK.
2. Select the handshake digit and press OK.
3. The keypad beeps once to accept the change.
4. Scroll to Kiss Off Digit and press OK.
• Select the kiss off digit and press OK.
• Select Any Digit to program any key press as the handshake/kiss off digit. This is the
default.
• Select None to disable kiss off.
To Next Page
Loading...
Need help?
General
