NX-10 Expander Installation Guide
17
Programming badge functions
Each of the three badging actions can activate a particular function. The following example explains
how to enable keyfob function 1 for the single badge action on proximity reader 113. To enable this
function, you must also program the keyfob function in RF Receivers. For more information see
chapter 9.
1. Navigate with the ½¾ keys to NX-1701E>Prox Reader 113 and press OK.
2. Scroll to Badge Functions>Single badge (1 beep)>Keyfob Funct 1>Yes and press OK.
3. The keypad beeps once to accept the change and returns to Keyfob Funct 1.
Configuring X-10 functions
You can program the X-10 function that is performed when a card is scanned. The following example
enables X-10 device 4 (module number 6, house code B) for the double badge action on proximity
reader 113. To activate the double badge action, you must set the scan time. In this example, it is set
to 1 second.
1. Navigate with the ½¾ keys to NX-1701E>Prox Reader 113 and press OK.
2. Scroll to Feature Select>Card Scan Mode>Single/Double/Hold and press OK.
3. The keypad beeps once to confirm the change and returns to Card Scan Mode.
4. Navigate with the ½¾ keys to Badge Functions>Double Badge (2 Beeps)>Broadcast X10
Function>Yes and press OK.
5. The keypad beeps once to confirm the change and returns to Broadcast X10 Function.
6. Navigate with the ½¾ keys to X-10 Functions>Unit Code and press OK.
7. Select 6 and press OK.
8. The keypad beeps once to confirm the change and returns to Unit Code.
9. Scroll to House Code and press OK.
10. Select B and press OK.
11. The keypad beeps once to confirm the change and returns to House Code.
12. Scroll to Functions>Double Badge (2 Beeps)>On and press OK.
13. The keypad beeps once to accept the change and returns to Double Badge (2 Beeps).
14. Navigate with the ½¾ keys to Miscellaneous>Scan Time and press OK.
15. Select 100 x 10 ms and press
OK.
16. The keypad beeps once to accept the change and returns to Scan Time.
To Next Page
Loading...
Need help?
General
