GE NX-10 Installation Guide

Appendix 2 Installing the modules
Large polycarbonate housing
Figure 19. Opening the box and installing NX-10 in a large polycarbonate housing.
1. Unscrew the holding screw in the polycarbonate housing.
2. Open the box.
3. Lift off the lid of the box.
4. Flip up the PCB mounting tray.
If you are using a NX-534E and a NX-535:
5. Connect the NetworX bus cables to the NX-534E listen-in module (DATA, POS, and
COM contacts).
6. Plug-in the 5-pin audio cable connector to the audio tap on the NX-534E listen-in
module.
7. Remove the sticky pads and insert the pillars for the NX-534E listen-in module in the
box.
8. Connect the NX-534E listen-in module to the box.

GE NX-10 Specifications

General

Brand	GE
Model	NX-10
Category	Security System
Language	English