GE NX-10 Installation Guide

NX-10 Expander Installation Guide
19
Task Steps
Delete one user
1. Select User Menu>NX-17xx Readers>Delete One Card.
2. Enter the user number assigned to the card and press OK.
3. Badge a card at the reader.
4. The user card information for the entered user number will be cleared and LED1 stops
flashing. After about 40 seconds, all the readers in the system are updated with the new
user card information.
Activate a card
1.Select User Menu>NX-17xx Readers>Activate Card.
2.Enter the user number assigned to the card and press OK.
3.The user card information for the entered user number will be activated and LED1 stops
flashing. After about 40 seconds, all the readers in the system are updated with the new
user card information.
Deactivate a card
1. Select User Menu>NX-17xx Readers>Deactivate Card.
2. Enter the user number assigned to the card and press OK.
3. The user card information for the entered user number will be deactivated and LED1
stops flashing. After about 40 seconds, all the readers in the system are updated with the
new user card information.
Glossary
Location Term Definition
6 NX-1701E Proximity Readers A proximity card reader/door control module that can be
programmed to control access in any or all partitions.
6.1 Prox Reader 113 A menu entry that groups all options for the selected
proximity reader.
6.1.1 Badge Functions A menu entry that groups the functions activated by Single
Badge, Double Badge and Badge Hold actions.
6.1.1.1 Single Badge (1 Beep) A menu entry that groups the functions activated by
holding a proximity card once against the proximity reader.
6.1.1.2 Double Badge (2 Beeps) A menu entry that groups the functions activated by
holding a proximity card against the proximity reader twice
within the time set in Badge Hold.
6.1.1.3 Badge Hold (3 Beeps) A menu entry that groups the functions activated by
holding a proximity card near the proximity reader for
longer than the time set in Badge Hold.
6.1.1.1.1 Send Code Entry Function A menu option that enables the send code entry function
for the selected proximity reader action. The actions are
Single Badge, Double Badge and Badge Hold. This function
sends the same command to the control panel, using the
proximity card, as a keypad would send if a valid code
were entered. For example, if the system is armed, the
selected action disarms it.

GE NX-10 Specifications

General

Brand	GE
Model	NX-10
Category	Security System
Language	English