NX-10 Expander Installation Guide
147
Location Term Definition
14.9 Version A menu option that displays the current software version of
the selected module.
14.10 Reset Settings A menu option that defaults the selected module to factory
defaults.
Programming the locations for NX-590E
(Defaults are in bold italic text)
LOC DESCRIPTION DEFAULT PROGRAMMING DATA
MODULE MODE OF OPERATION
SEGMENT 1
1 Use control dialer as backup to TCP/IP and email OFF
2
Backup Format (Off = CID, On = SIA) OFF
3 Use Receiver #2 as Backup OFF
4 Send Tag to On-Site Event Recorder OFF
5 Reserved
6 Reserved
7 Reserved
8 Reserved
SEGMENT 2
1 Enable site initiated downloading ON
2 Enable remote initiated downloading ON
3 Use DHCP services (static IP of unit if OFF)
Note: If enabled, it is recommended that option 8 also be
enabled.
OFF
4 Reserved
5 Reserved
6 Reserved
7 Reserved
0
8 Polling enable (for UL AA) OFF
PARTITIONS TO REPORT BY INTERNET TO RECEIVER #1
1
Alarms and Restores
2 Open/Close
3 Bypass
4 Zone Trouble
5 Power Trouble (AC Failure or Low Battery)
6 Siren & Telephone Fault
7 Test Reports
8 Program, Download & Log Full
9 Tampers
10 Short Circuit & Ground Fault
11 Sensor Lost
12 Sensor Low Battery
13 Expander Trouble
14 Failure to Communicate
15 Zone Activity Monitor
1
16 Reserved
To Next Page
Loading...
Need help?
General
