NX-10 Expander Installation Guide
135
Chapter 9 Setting up the NX-590E
Overview
The NX-590E TCP/IP module is a dual microprocessor-controlled Internet/Intranet interface used to
connect the NX-10 control panel to the OH Network Receiver. This interface allows any or all events
from the NX-10 to be reported over the network. The NX-590E TCP/IP module features include:
• Four programmable report destinations (two TCP/IP receivers, two email addresses).
• Event reporting from all partitions.
• Selectable reportable events for each partition.
• Control panel as backup.
• SIA reporting using TCP/IP.
• Contact ID reporting using TCP/IP.
• Email reporting in English and on POP server only.
• DHCP or fixed IP address.
• Upload/download may be initiated remotely or locally.
• Optional automatic download sessions. These normally follow test calls. Test call
reporting can be switched off so that there is automatic download calls without test
report calls.
To Next Page
Loading...
Need help?
General
