GE NX-10 Installation Guide

NX-10 Expander Installation Guide
141
6. The keypad beeps once to accept the change and returns to IP Address.
7. Scroll to Auto U/D at Test Time>Enabled and press OK.
8. The keypad beeps once to accept the change and returns to Auto U/D at Test Time.
9. Navigate with the ½¾ keys to Options>Network>Port Numbers and press OK.
10. Scroll to TCP/IP Alarm Port and press OK.
11. Enter the number of the port and press OK.
12. The keypad beeps once to accept the change and returns to TCP/IP Alarm Port.
Glossary
Location Term Definition
14 NX-590E A module that operates as an Ethernet communications
module for reporting and upload/download.
14.1 TCP/IP Reporting A menu entry that groups TCP/IP reporting options.
14.1.1.1 IP Address A menu option that configures the address of the selected
TCP/IP receiver.
14.1.1.2 Events A menu entry that contains all configurable events for each
receiver or email account. All partitions are enabled by
default. Enabled events are formatted into one or more
messages according to pre-configured settings and sent to
the selected report destination or email address.
Select the partition(s) to include for each event report. If
the partition is not selected, no event from that partition
reports via the network regardless of what is programmed
elsewhere.
14.1.1.2.1 Arm/Disarm/Alarm A menu entry that groups the events that are reported to
the selected receiver.
14.1.1.2.1.1 Alarms and Restores A menu option that sends a report to the selected receiver
when an alarm occurs and when the alarm has been
restored.
14.1.1.2.1.2 Opening/Closing A menu option that sends a report to the selected receiver
stating when the system is opened (disarmed) and closed
(armed).
14.1.1.2.1.3 Zone Bypass and Restores A menu option that sends a report to the selected receiver
when a zone is bypassed. A report is also sent when the
zone is restored (un-bypassed).
14.1.1.2.2 Tamper/Fault A menu entry that groups together the tamper and fault
events that are reported to the selected receiver.
14.1.1.2.2.1 Tampers A menu option that sends a report to the selected receiver
when a tamper occurs.
14.1.1.2.2.2 Zone Trouble and Restores A menu option that sends a report to the selected receiver
when a zone fault condition occurs. A report is also sent
when the fault condition is no longer active.

GE NX-10 Specifications

General

Brand	GE
Model	NX-10
Category	Security System
Language	English