NX-10 Expander Installation Guide
133
(*) Only if Handshake and Kiss-Off are enabled on location 1.
Notes: The voice protocol can NOT generate a ‘fail to communicate’ signal.
All alarm reports will be cancelled and the voice module will stop dialling when a valid user code is entered on a
keypad.
NX-535 Programming worksheets
(Defaults are in bold italic text)
LOC DESCRIPTION DEFAULT
RECORDING / PLAYBACK SETTINGS
Segment 1
0 Cancel operation
1 Recording mode
2 Playback mode
Segment 2
0 Record / playback leader message
1 Record / playback event message 1
2 Record / playback event message 2
3 Record / playback event message 3
4 Record / playback event message 4
5 Record / playback event message 5
6 Record / playback event message 6
7 Record / playback event message 7
8 Record / playback event message 8
9 Record / playback event message 9
10 Record / playback event message 10
11 Record / playback event message 11
12 Record / playback event message 12
13 Record / playback event message 13
14 Record / playback event message 14
15 Record / playback event message 15
16 Record / playback kiss-off message
17 Record / playback address message
0
18 Reserved
CONFIGURING HANDSHAKE AND KISS-OFF
Segment 1
Handshake DTMF digit
15
1
Segment 2
Kiss-off DTMF digit
15
To Next Page
Loading...
Need help?
General
