HP XP P9500 User Manual

Table 36 How to Prepare the Configuration Files at each site (3DC Cascade Configuration) (continued)
How to PrepareContentsFile Type
On the Secondary SiteOn the Primary Site
Not requiredDefine a path setPath set definition file
• An inter-control unit
logical path from the
primary site to the
intermediate site
• An inter-disk controller
logical path from the
intermediate site to the
remote site
Define a path setNot required
• An inter-control unit
logical path from the
intermediate site to the
primary site
• An inter-disk controller
logical path from the
remote site to the
intermediate site
Not requiredDefine a route listA route/command device
from the primary site, to the
Route list definition
file/Command device
definition file intermediate site, and then
the remote site
Define a route listNot requiredA route/command device
from the remote site, to the
intermediate site, and then
the primary site
Transfer from the primary
site
Define a copy groupA Cnt Ac-S Z copy groupCopy group definition file
Define a copy groupA Cnt Ac-J Z copy group
NOTE: If you define the route list, the route list definition file and the command device definition
file will be created at the same time.
Definition procedure (3DC Cascade configuration)
First, set the items that need to be set by using Remote Web Console from among the items listed
in Table 34 (page 137).
This section explains how to set up a 3DC Cascade configuration from the ISPF panel.
The following shows the legend for the figure in the operation procedure of this section:
Defining a 3DC Cascade configuration 139

HP XP P9500 Specifications

General

Brand	HP
Model	XP P9500
Category	Software
Language	English