HP XP P9500 User Manual

Table 45 How to Prepare the Configuration Files at Each Site (Delta Resync Configuration) (continued)
How to PrepareContentsFile Type
On the Secondary SiteOn the Local SiteOn the Primary Site
definition file primary siteprimary siteMainFrame group
Define a copy groupA Cnt Ac-J copy for
MainFrame group
Define a copy groupA Cnt Ac-J copy for
MainFrame group for
Delta Resync
NOTE: If you define the route list, the route list definition file and the command device definition
file will be created at the same time.
Definition Procedure (Delta Resync Configuration)
First, set the items that need to be set by using Remote Web Console from among the items listed
in Table 42 (page 162) (excluding a Delta Resync control path).
This subsection explains the definition procedure in Business Continuity Manager. A delta resync
configuration is defined in the following procedure.
1. Create a disk configuration definition file.
Create a disk configuration definition file by performing a Local Scan on each site, and then
transfer the file to the other sites.
2. Perform setup on the primary site.
On the primary site, create the necessary path set definition file and route list definition file,
establish a logical path, and register a command device.
3. Perform setup on the local site.
On the local site, create the necessary path set definition file and route list definition file,
establish a logical path, and register a command device.
4. Specify settings on the remote site.
On the remote site, create the necessary path set definition file and route list definition file,
establish a logical path, and register a command device.
5. Create copy groups.
On the primary site, define copy groups and make copy pairs.
For details on each definition procedure in this section, see the following:
• Procedure for a local scan
For details, see “Performing a local scan to acquire volume information” (page 106). For details
on how to operate the ISPF panels, see “Local scan procedure” (page 430).
• Procedure for defining a path set and for establish a logical path
For details, see “Establishing a logical path” (page 112). For details on how to operate the
ISPF panels, see “Creating a path set” (page 439) and “Establishing a logical path” (page 456).
• Procedure for defining a route list
For details, see “Defining the route list” (page 118). For details on how to operate the ISPF
panels, see “Defining a route list” (page 457).
166 Configuration Definitions

HP XP P9500 Specifications

General

Brand	HP
Model	XP P9500
Category	Software
Language	English