6. Press the F4=Attr key.
The Copy Group Attributes (CAA) panel appears.
7. Specify copy group attributes.
8. Press the Enter key.
The Copy Group Pair Detail panel appears.
Adding the copy pair to the copy group (Cnt Ac-A)
The operations for adding a copy pair to a Cnt Ac-A copy group are the same as those in “Adding
the copy pair to the copy group (Cnt Ac-J Z)” (page 480).
Defining a copy group container
This section explains the procedures that are required to define a copy group container. They are
as follows:
• Defining the copy group ID and copy group attributes
• Adding a consistency group
• Changing a copy group that is not a copy group container to one that is a copy group
container (adding a C/T group)
• Changing a copy group that is a copy group container to one that is not a copy group
container (deleting a C/T group)
• Defining an EXCTG
• Saving the contents of the settings
Defining a copy group container 485
To Next Page
Loading...
Need help?
General