HP XP P9500 User Manual

Table 16 Copy pair statuses of volumes obtained by the YKQRYDEV command (BC Z) (continued)
DescriptionStatus of the copy pair in the
storage system
Copy pair status acquired by
YKQRYDEV
Resynchronization is being performed.Resync-RREVRSY (08)
In transition to Simplex status.DeletingTRANS (09)
Using the YKQUERY command to obtain the copy pair status for each copy pair
You can use the YKQUERY or YKEWAIT command or the Copy Group Pair Status panel to obtain
the copy pair status for each copy pair.
The copy pair status for each copy pair is determined by the combination of the copy pair statuses
of the P-VOL and S-VOL.
For Continuous Access Synchronous for Mainframe, Continuous Access Asynchronous for Mainframe,
or Continuous Access Journal for Mainframe, if the command is executed for a remote storage
system when a command device has not been defined, the copy pair status for the remote storage
system is not displayed.
CAUTION: If you attempt to obtain copy pair information from an inaccessible site (due to a line
failure, for example), an error will occur even if information from available sites has been obtained.
You can prevent the error in such cases by executing the YKQUERY command with the TO parameter
specified. This parameter allows you to specify the site (P-VOL or S-VOL when they were defined)
from which information can be obtained. For details about the information that can be obtained
by the YKQUERY command with the TO parameter, in the HP StorageWorks P9000 for Business
Continuity Manager Software Reference Guide, see the explanation of the REXX variable that is
updated by the YKQUERY command with the TO parameter.
NOTE: The YKQUERY and YKEWAIT commands determine the copy pair status based on the
collected information, even if the defined copy types or combinations of copy pairs differ from
actual copy types or the defined combinations of copy pairs.
The following common legend is used for Table 17 (page 70) through Table 19 (page 71), which
show the correspondence between the P-VOL and S-VOL statuses and the copy pair statuses for
each copy pair.
SMP: SIMPLEX
PND: PENDING
DUP: DUPLEX
SOP: SUSPOP
SCU: SUSPCU
SER: SUSPER
SU-P: SUSPEND-PENDING, which is in transition to suspend status.
SI-P: SIMPLEX-PENDING, which is in transition to SIMPLEX status.
CON: CONSLOST
INV: INVALID
TRN: TRANS
HLD: HOLD
HER: HOLDER
HTR: HOLDTRNS
NDL: NODELTA
Understanding Copy Group Operations 69

HP XP P9500 Specifications

General

Brand	HP
Model	XP P9500
Category	Software
Language	English