8. Use Remote Web Console to change the timer type of the existing journal groups contained
in the Continuous Access Journal Z copy group (URG1) from LOCAL to SYSTEM.
9. Execute the YKRESYNC command for the Continuous Access Journal Z copy group (URG1) to
resynchronize the copy pairs.
10. Execute the YKEWAIT GOTO(DUPLEX)command for the Continuous Access Journal Z copy
group (URG1) to continue monitoring until the status has changed to DUPLEX.
11. Execute the YKQUERY command for the Continuous Access Synchronous Z copy group container
(TCCG).
12. Execute the YKMAKE SELECT(COND) command for the Continuous Access Synchronous Z
copy group container (TCCG).
13. Execute the YKEWAIT GOTO(DUPLEX) command for the Continuous Access Synchronous Z
copy group container (TCCG) to continue monitoring until the status has changed to DUPLEX.
A copy pair for the added storage system is created.
14. Execute the YKQUERY command for the Continuous Access Journal Z EXCTG (UREX).
Because an existing journal group has not been registered in the EXCTG yet, the YKZ296E
message indicating that the journal group has not been registered in the EXCTG is output.
Defining a 4x4x4 Cascade Configuration 229
To Next Page
Loading...
Need help?
General