Table 40: CTP Bundle IRIG-B Port Parameter Settings in the CTP Menu (continued)
Your ActionFunctionField
Select one:
•
4WTO/IRIG - Master End—This end
of the circuit generates a clock signal
and sends it to the remote end.
•
4WTO/IRIG - Adaptive End—This end
of the circuit receives the clock signal
from the remote end. The clock slave
uses its period to determine when to
sample data and how to transmit data
across the link.
•
Custom—The custom clocking
configuration is used.
Specifies the type of clocking for the
bundle.
Clock Config
Configuring Advanced Port Options for CTP Bundles (CTPView)
Before you begin:
•
Log in to the CTPView software at least at the Net_Admin level.
•
Connect the CTPView server to the CTP device for which you want to configure bundles.
To configure advanced port options for CTP bundles using CTPView:
1. In the side pane, select Bundle > Configuration.
2. Run your mouse over the Display and Select an Existing Bundle bar.
3. In the table of bundles, select the bundle that you want to modify.
4. Under Port Options, select the Advanced Options Show to display advanced
parameters and configure the parameters as described in Table 41 on page 96.
5. Click Click to Submit Bundle AND Port Changes.
Table 41: CTP Bundle Advanced Port Options Settings in CTPView
Your ActionFunctionField
Select ENABLED or
DISABLED.
Do not change this value without consulting JTAC.
Specifies whether or not the CTP device drives received data (RD)
onto data set ready (DSR) and real-time (RT) data onto test mode
(TM).
Single Ended Data/Clock
Output
Select ENABLED or
DISABLED.
Do not change this value without consulting JTAC.
Specifies whether or not to reclock RD with the RT clock to align the
data and the clock.
Reclock to Align Clock
and Data
Copyright © 2018, Juniper Networks, Inc.96
Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3
To Next Page
Loading...
Need help?
General
