Related
Documentation
Configuring Multiservice 4WTO Mode Port Parameters for CTP Bundles (CTP Menu)
on page 84
•
Configuring IRIG-B Port Parameters for CTP Bundles (CTPView)
This topic describes how to configure port parameters for IRIG-B daughter cards.
Adaptive clocking is configured by default on IRIG-B bundles, and the packet size is set
to 64 bytes. The packet size combined with the default data rate of 16 Kbps produces a
packet rate of 32 pps, which is a good packet rate for adaptive clocking.
Before you begin:
•
Log in to the CTPView software at least at the Net_Admin level.
•
Connect the CTPView server to the CTP device for which you want to configure bundles.
To configure IRIG-B port parameters using CTPView:
1. In the side pane, select Bundle > Configuration.
2. Run your mouse over the Display and Select an Existing Bundle bar.
3. In the table of bundles, select the bundle that you want to modify.
4. Under Bundle Options, configure the parameters as described in Table 39 on page 92
and click Click to Submit Bundle AND Port Changes.
Table 39: CTP Bundle IRIG-B Port Parameter Settings in CTPView
Your ActionFunctionField
Enter a description of up to 64 alphanumeric
characters. Do not use the following
characters:
( ; ' " ) ]
Specifies a description for the port.Port
Description
Select DCARD.Specifies the daughter card as the interface type.I/F Type
Enter a number from 1.000 through 25.500
KHz. The port speed must be a multiple of 100
bps.
Specifies the data rate on the IP connection.
Unless network bandwidth is at a premium, we do not
recommend that you change this value from the default of
16,000 bps.
Port Speed
Copyright © 2018, Juniper Networks, Inc.92
Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3
To Next Page
Loading...
Need help?
General
