Table 21: CTP Bundle Serial Port Parameter Settings in CTPView (continued)
Your ActionFunctionField
Select one:
•
EIA-530
•
EIA-530A
•
RS-232
•
V.35
•
DCARD
•
OFF—Do not set the interface type to
OFF.
Specifies the electrical standard used
on the serial interface.
You can install the following optional
daughter cards on a serial interface:
•
T1/E1 (CTP1000 and CTP2000 series)
•
4WTO (CTP1000 and CTP2000
series)
•
IRIG-B (CTP2000 series only)
•
Multiservice Daughter Cards (CTP
2000 and CTP150 series)
I/F Type
Enter a number from 0.00100 through
12880.00000 KHz.
Specifies the speed of the port. In
networks without bandwidth
constraints, we recommend a multiple
of 10.
The port speed recommendations vary
according to encoding type:
•
For transparent mode circuits, the
port speed is the sample rate for user
data. Therefore, port rate should be
a multiple of the user data rate.
•
For CDI circuits, the port speed is
limited to 4608 KBps.
The port speed also varies depending
on hardware:
•
CTP2000 devices cannot have an
aggregate port rate greater than
114.688 Mbps.
Port Speed
Configuring Serial Port Parameters for CTP Bundles (CTP Menu)
This topic describes how to configure port parameters for serial interfaces.
Before you begin:
•
Disable the bundle before you modify the bundle options.
To configure serial port parameters for CTP bundles using the CTP Menu:
1. From the CTP Main Menu, select 1) Bundle Operations.
2. Select 1) CTP.
3. Select a bundle from the list.
Copyright © 2018, Juniper Networks, Inc.54
Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3
To Next Page
Loading...
Need help?
General
