Table 35: CTP Bundle Multiservice TDC Port Parameter Settings in the CTP Menu
Your ActionFunctionField
Select TDC/IRIG.Specifies that the bundle will run in TDC
mode.
Mode
Select one:
•
Src (signal enters CTP)—End of the
circuit that receives NRZ/IRIG data.
•
Dst (signal exits CTP)—End of the
circuit that sends NRZ/IRIG data
toward the network.
Specifies the direction of the circuit.Src/Dest
Enter a number from 500 through
5,000,000 bps. The port speed must be
a multiple of 500 bps.
Specifies the data rate on the IP
connection.
NRZ/Rate
Enter a number from 0 through 255.Specifies the output level.
Note the following information about the
values:
•
0—There is no output.
•
128—Unity gain, which means there is
no attenuation or gain.
•
255—Gain is 2:1.
IRIG Output Level
See Also Serial Multiservice Interface Module Overview on page 5•
Configuring Multiservice 4WTO Mode Port Parameters for CTP Bundles (CTP Menu)
Before you begin:
•
Disable the bundle before you modify the bundle options.
To configure Multiservice 4WTO mode port parameters using the CTP Menu:
1. From the CTP Main Menu, select 1) Bundle Operations.
2. Select 1) CTP.
3. Select a bundle from the list. The bundle port must have a 4WTO daughter card
installed.
If you select an active bundle, you are prompted to disable the bundle before
configuring it.
4. Select 3) Port Config.
5. Select 2) Interface.
Copyright © 2018, Juniper Networks, Inc.84
Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3
To Next Page
Loading...
Need help?
General
