6. Select 1) Type and set the type to Optional Interface: MultiSvc.
7. Configure the options as described in Table 36 on page 85.
Table 36: CTP Bundle Multiservice 4WTO Port Parameter Settings in the CTP Menu
Your ActionFunctionField
Select 4WTO-Em.Specifies that the bundle will run in
4WTO mode.
Mode
Select one:
•
Master—This end of the circuit
provides clocking.
•
Slave—This end of the circuit uses
adaptive clocking.
Specifies whether this end of the circuit
provides clocking or uses adaptive
clocking.
If the CTP devices at both ends of the
circuit are synchronized, you can
configure both ends as Master.
Master/Slave
Select one:
•
Disable—Channel 0 is the only active
channel.
•
Enable—Both channel 0 and channel
1 are active.
Two channels are supported—channel
0 and channel 1.
Enables or disables the use of both
channels.
Dual Channel
Select one:
•
Disable—Disables the active squelch
function on the circuit.
•
Enable and active—Squelch input is
grounded and analog output is
disabled.
•
Enable and inactive—No signal is
applied to the squelch input. Input is
open and analog output is possible.
Enables or disables the active squelch
function on the circuit.
If enabled, specifies whether the squelch
is active or inactive.
The squelch function gates local audio
output when DSR-A (channel 0) or
RTS-A (channel 1) inputs are active or
inactive.
Talk Squelch
Enter a number from 0 through 255.Specifies the output level for channel 0.
Note the following information about the
values:
•
0—There is no output.
•
128—Unity gain, which means there is
no attenuation or gain.
•
255—Gain is 2:1.
Ch 0 Output Level: 1.00x (decimal 128)
Enter a number from 0 through 255.Specifies the output level for channel 1.
Note the following information about the
values:
•
0—There is no output.
•
128—Unity gain, which means there is
no attenuation or gain.
•
255—Gain is 2:1.
Ch 1 Output Level: 1.00x (decimal 128)
85Copyright © 2018, Juniper Networks, Inc.
Chapter 2: Configuring CTP Bundles
To Next Page
Loading...
Need help?
General
