*** after the system reboots.
***
Are you sure? y[n]:
4. When prompted, specify a value for the protocol ID for data packets in the range
2-254. The default value is 46.
To configure a CTP Bndl OAM port (IPv6):
1. From the Main Menu, select 5) Node Operations.
2. Select 3) Configure network settings.
3. Select 7) CTP Bndl OAM port (IPv6).
4. When prompted, specify a port number for OAM packets in the range 2 through 254.
The default value is 16.
Ethernet Media Configuration Overview
You can configure the CTP Ethernet media to autonegotiate and set the speed to either
100 or 10 Mbps. By default, autonegotiation is enabled and the speed is to 1000 Mbps.
If you choose to disable autonegotiation, the system prompts you to configure the desired
speed.
The Ethernet configurations on CTP must match the configuration of the connected
router or switch. Mismatched configurations, such as setting the CTP system to
autonegotiate and the router to full duplex, will result in a misconfiguration and dropped
packets. You must disable Cisco Discovery Protocol on the Fast Ethernet port connected
to the CTP system.
Table 10 on page 32 lists the valid Ethernet media configuration settings that CTP Series
supports.
Table 10: Valid Ethernet Media Configuration Settings for CTP
MTU (up to 1500)Mode (Duplex)Autoneg StatusSpeed
anyFullON1000
anyFullOFF100
anyFullOFF10
NOTE: The CTP system supports only full duplex mode.
Copyright © 2018, Juniper Networks, Inc.32
Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3
To Next Page
Loading...
Need help?
General
