3. Select 1) Enable to enable gathering node debugging information.
The functionality of gathering node debugging information is disabled by default.
Selecting the Type of Clocking on Serial Ports for CTP Bundles (CTPView)
This topic describes how to select the type of clocking that you want to use on serial
ports. The type of clocking supported depends on the type of encoding you are using.
Before you begin:
•
Log in to the CTPView software at least at the Net_Admin level.
•
Connect the CTPView server to the CTP device for which you want to configure bundles.
To specify the clocking type for CTP bundles using CTPView:
1. In the side pane, select Bundle > Configuration.
2. Run your mouse over the Display and Select an Existing Bundle bar.
3. In the table of bundles, select the bundle that you want to modify.
4. Under Port Options, select a clocking type in the Clock Cfg field. Table 48 on page 105
describes the clocking types that are supported for each encoding type.
5. Click Click to Submit Bundle AND Port Changes.
Copyright © 2018, Juniper Networks, Inc.104
Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3
To Next Page
Loading...
Need help?
General
