Juniper CTP Series User Manual

Table 8: CTP Bundle Advanced Options Parameter Settings for Circuit Startup in CTPView
Your ActionFunctionField
Enter a number from 1
through 255.
Specifies the number of OAM packets per second that the circuit
sends to the remote CTP device.
OAM Packet Spacing
Enter a number from 1
through 255.
Specifies the number of OAM packets that the circuit must receive
before the state moves from no synchronization to in
synchronization.
OAM Packets for Sync
Enter a number from 1
through 255.
Specifies the number of received OAM packets that the CTP device
misses before the state of the circuit moves from in synchronization
to no synchronization.
OAM Packets for Sync
Loss
Enter a number from 1
through 64.
Specifies how many consecutive circuit packets the IP network
must drop before the CTP device restarts the circuit.
We recommend that you set the parameter to a larger value when
the IP network uses packet-encrypting devices. These devices cause
momentary interruption in packet flows when encryption keys are
updated.
Consecutive Pkt Loss To
Starvation
Enter a number from 1
through 64.
Specifies the number of in-sequence packets the CTP device must
receive after a starvation before the circuit transitions from in-sync
to running.
InSync Pkts After
Starvation
Related
Documentation
Circuit Startup Process Overview on page 11•
Configuring Circuit Startup Parameters for CTP Bundles (CTP Menu)
This topic describes how to configure advanced options that are related to circuit startup.
Set these parameters to the same values on the local and remote CTP devices.
Before you begin:
•
Disable the bundle before you modify the bundle options.
To configure circuit startup parameters using the CTP Menu:
1. From the CTP Main Menu, select 1) Bundle Operations.
2. Select 1) CTP.
3. Select a bundle from the list.
If you select an active bundle, you are prompted to disable the bundle before
configuring it.
4. Select 2) Config.
Copyright © 2018, Juniper Networks, Inc.30
Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3

Juniper CTP Series Specifications

General

Brand	Juniper
Model	CTP Series
Category	Server
Language	English