See Also Serial Multiservice Interface Module Overview on page 5•
Configuring Multiservice TDC Mode Parameters for CTP Bundles (CTPView)
Before you begin:
•
Log in to the CTPView software at least at the Net_Admin level.
•
Connect the CTPView server to the CTP device for which you want to configure bundles.
To configure Multiservice TDC mode port parameters using CTPView:
1. In the side pane, select Bundle > Configuration.
2. Run your mouse over the Display and Select an Existing Bundle bar.
3. In the table of bundles, select the bundle that you want to modify.
4. Under Bundle Options, configure the parameters as described in Table 31 on page 76
and click Click to Submit Bundle AND Port Changes.
Table 31: CTP Bundle Multiservice TDC Port Parameter Settings in CTPView
Your ActionFunctionField
Enter a description of up to 64 alphanumeric
characters. Do not use the following characters:
( ; ' " ) ]
Specifies a description for the port.Port Description
Select DCARD.Specifies the daughter card as the interface type.I/F Type
Select TDC.Specifies that the bundle will run in TDC mode.Multi-Service Mode
Select one:
•
Source (signal enters CTP)—End of the circuit
that receives NRZ/IRIG data.
•
Destination (signal exits CTP)—End of the circuit
that sends NRZ/IRIG data toward the network.
Specifies the direction of the circuit.TDC Source
Enter a number from 500 through 5,000,000 bps
in multiples of 500.
Specifies the NRZ data rate on the IP connection.TDC NRZ Rate
Enter a number from 0 through 255.Specifies the output level.
Note the following information about the values:
•
0—There is no output.
•
128—Unity gain, which means there is no
attenuation or gain.
•
255—Gain is 2:1.
TDC IRIG Output Level
Copyright © 2018, Juniper Networks, Inc.76
Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3
To Next Page
Need help?
General
