Juniper CTP Series User Manual

Table 22: CTP Bundle Serial Port Parameter Settings in the CTP Menu (continued)
Your ActionFunctionField
Specify y (yes) or n (no).Specifies whether adaptive clocking is
enabled for this circuit.
If both end nodes are not locked to a
clock reference, we recommend that you
enable one end (not both) for adaptive
clocking
Appears only if you select ISOCH, CDI,
TRANS, or TDM encoding.
Enable adaptive clocking?
Specify y (yes) or n (no).If you enabled adaptive clocking,
specifies whether or not to initialize
adaptive clocking parameters to their
default values, which depend on port
speed, packet size, and buffering
parameters set on the bundle.
We recommend the following settings:
•
If you are configuring the bundle for
adaptive clocking for the first time,
enter y.
•
If you have previously configured the
bundle to optimize adaptive clocking
for this network, enter n.
Initialize adaptive clocking parameters?
y[n]: y
This option is used for TDM/TDC
operation. See “Configuring the
High-Speed CTP Bundle for TDM/TDC
Operation (CTP Menu)” on page 64.
TDC Clk/Data on port N+1
This option is used for TDM/TDC
operation. See “Configuring the
High-Speed CTP Bundle for TDM/TDC
Operation (CTP Menu)” on page 64.
TDM rates
57Copyright © 2018, Juniper Networks, Inc.
Chapter 2: Configuring CTP Bundles

Juniper CTP Series Specifications

General

Brand	Juniper
Model	CTP Series
Category	Server
Language	English