Juniper CTP Series User Manual

Table 29: CTP Bundle Multiservice Audio Port Parameter Settings in CTPView (continued)
Your ActionFunctionField
Select one:
•
DISABLED—Disables the active squelch
function on the circuit (audio output is
always enabled).
•
ENABLED/ACTIVE—Squelch input is
grounded and analog output is disabled.
•
ENABLED/INACTIVE—No signal is applied
to the squelch input. Input is open and
analog output is possible.
Enables or disables the active squelch function on the
circuit.
If enabled, specifies whether the squelch is active or
inactive.
The squelch function gates local audio output when DSR-A
(channel 0) or RTS-A (channel 1) inputs are active or
inactive.
Audio Squelch
Enter a number from 0 through 255.Specifies the output level for channel 0.
Note the following information about the values:
•
0—There is no output.
•
128—Unity gain, which means there is no attenuation or
gain.
•
255—Gain is 2:1.
Audio Channel 0
Output Level
Enter a number from 0 through 255.Specifies the output level for channel 1.
Note the following information about the values:
•
0—There is no output.
•
128—Unity gain, which means there is no attenuation or
gain.
•
255—Gain is 2:1.
Audio Channel 1
Output Level
See Also Serial Multiservice Interface Module Overview on page 5•
Configuring Multiservice IRIG-B Mode Port Parameters for CTP Bundles (CTPView)
Before you begin:
•
Log in to the CTPView software at least at the Net_Admin level.
•
Connect the CTPView server to the CTP device for which you want to configure bundles.
To configure Multiservice IRIG-B mode port parameters using CTPView:
1. In the side pane, select Bundle > Configuration.
2. Run your mouse over the Display and Select an Existing Bundle bar.
3. In the table of bundles, select the bundle that you want to modify.
4. Under Bundle Options, configure the parameters as described in Table 30 on page 75
and click Click to Submit Bundle AND Port Changes.
Copyright © 2018, Juniper Networks, Inc.74
Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3

Juniper CTP Series Specifications

General

Brand	Juniper
Model	CTP Series
Category	Server
Language	English