Juniper EX Series User Manual

Table 50: Create a New Term (continued)
Your ActionFunctionField
Select the match conditions as specified in Table 51 on page 93.
Select the packet action for the term as specified in
Table 51 on page 93.
Specifies advanced configuration options for
the filter.
More
Table 51: Advanced Options for Terms
Your ActionFunctionTable
Select the option from the
list.
Specifies the ICMP packet type field. Typically, you specify this
match condition in conjunction with the protocol match
condition to determine which protocol is being used on the
port.
ICMP Type
Select a value from the list.Specifies more specific information than the ICMP type.
Because the value’s meaning depends upon the associated
ICMP type, you must specify icmp-type along with icmp-code.
The keywords are grouped by the ICMP type with which they
are associated.
ICMP Code
Select the DSCP number
from the list.
Specifies the Differentiated Services code point (DSCP). The
DiffServ protocol uses the type-of-service (ToS) byte in the IP
header. The most significant six bits of this byte form the DSCP.
DSCP
Select the option from the
list.
Specifies the IP precedence.
NOTE: The IP precedence and the DSCP number cannot be
specified together for the same term.
Precedence
Select the option from the
list.
Specifies the presence of the options field in the IP header.IP Options
Select the interface from the
list.
Specifies the interface on which the packet is received.Interface
Select a value from the list.Specifies the Ethernet type field of a packet.
NOTE: This option is not applicable for a routing filter.
Ether type
NOTE: This option is not
supported on EX4300
switches.
93Copyright © 2017, Juniper Networks, Inc.
Chapter 7: Routing Policies and Packet Filtering Configuration

Juniper EX Series Specifications

General

Brand	Juniper
Model	EX Series
Category	Switch
Language	English